Roses Wedding Cake
Creating a Wedding Cake is an art, and this case is not an exception. We are creating roses to decorate this beautiful Wedding Cake and in this cake we are using five to seven big decorating roses in each cake, and about five to six roses buds and leafs that are coming out to make the impression of a bundle of roses hanging on the borders of the cakes.
Accessories you will need:
- Sheet Cake Pan 12in x 18 in
6″, 8″, 10″ Round Pan
Cake Boards
13×19 in
- Cake Circles
8,10, 12 in (need to be 2 in bigger than the cake)
- Cakes/Dessert Stand
- Angled Spatula
- Decorating Bags
- Pastry Bag Coupler
- Tips #22, #18,#12, #104, #69
Decorating Tips
- Cake Icier (Tip 789 )
- Flower Nail
#7
- Wilton Rotating Trim ‘N Turn Turntable
- Buttercream icing
Instructions:
- Bake all the cakes.
- Get the sheet cakes and put them on the Cake Boards
- Get the round cakes and put them on their respective Cake Circles
size ( it will go 2″ bigger than the cake).
- Put the cake on the Rotating turntable
.
- Trim a 16 in Decorating Bag and put the Cake Icier (Tip 789 )
inside.
- With the Angled Spatula
fill half of the bag with Buttercream icing
.
- Put the bag in a 45 degree angle and press the tip to the cake and squeeze the icing on a spiral motion to cover the top of the cake.
- Ice the sides squeezing at the same time you turn the cake, until you cover the entire side of the cake.
- With a Angled Spatula
smooth sides and top of the cake.
- Mark the front of the cake and trace four semi-circle on the front side of the cake to decorate the garland of the cake.
- Get a bag and the Pastry Bag Coupler
and put inside the bag the base; inside the ring put the Decorating Tips
#22, and twist the two pieces together.
- Fill the bag and decorated the border with the shell technique.
- To do a shell technique, the tip need to be slightly above the cake; squeeze hard, letting the icing fan out as it lifts the tip. Relax the pressure as you lower the tip until it touches the surface, stop pressure and pull the tip away, don’t lift it off the surface and draw the shell to a point. To continue with the border, start were you end the shell and continue with a chain of shells.

- To do the garland, get the decorating bag and change the Decorating Tips
from #22 to a #18.
- Hold the bag in a angle of 45 degree to surface, squeeze out icing with a steady pressure, move your hand in a tight side -to- side motion as you curve hand down to the right and up forming a garland. Increase the pressure to make the garlands side at the center, and decreasing pressure to narrow the garlands at the end.

- Now to make the roses you will need to prepare two bags, one with Decorating Tips
#12, and the other with #104, and fill the bags with icing about half way.
- Hold the Flower nail
with one hand and with the other hand hold the bag with Decorating Tip #12, to make the rose base, holding the bag straight up, use heavy pressure to build up a base, your tip need to be buried as you squeeze, lift the tip higher,gradually raise the tip and decrease the pressure.
- Stop the pressure, pull up and and lift away. The base need to be 1 1/2 times as high the rose tip opening.

- Get the bag the with Decorating Tips
#104, hold the bag at 45 degree with the small end of the tip pointing up and toward center of the flower nail, press lightly into the base about halfway to top. Then pipe a ribbon out of icing, swinging it up, around and down to encircle top of base and form a pointed bud.

- Starting halfway up pipe a row of 3 petals around the base, turning the flower nail counter-clockwise and moving your hand up and down in a half-moon arch.

- Pipe 5 petals under the first row, turning the flower nail counter-clockwise. Touch wide end of the tip slightly below the center of top petal, angle narrow end of tip out slightly, so petals appear to be opening slightly.

- Pipe last row of petals, start at the center of petals above, point narrow end of the tip, a little far out and again the Flower nail
counter clockwise piping 7 more petals overlapping. Squeeze the bag and spin the flower nail to the end of your fingers, moving tip up, then down repeat this process until you count 7 petals.

- Do between 7 to 8 of this roses for each cake and set them on the cake as you like.

- Fill some spaces with some buds, fallowing steps 20 to 25 to make the rosebud.
- Fill one of the bags with green icing, and put the Decorating Tips
#69 (leaf tip).
- To pipe a leaf hold the tip at 45 degree and lightly touching surface , the wide opening need to be parallel to the surface.
- Squeeze hard to build up the base and lift the tip slightly; relax pressure as you pull the tip away, drawing the leaf to a point.
- Put 2 to 3 leaf under each rose, and fill empties spaces with leafs. Do not overfill.
- Now set the cakes on the Cake/ Dessert Stand
and decorated the stand with the satin material include and the poles with flowers ,leaf, tool or any other thin or decoration that you will like to use.
- Set your table with all your cakes and enjoy.
- I hope this instruction for making a Wedding Cake are helpful for you and that you are having fun making and learning on how to do all those roses and roses bud to decorated this beautiful Roses Wedding Cake. Enjoy your project!




June 16th, 2009 at 5:31 am
Hi. I like the way you write. Will you post some more articles?
June 16th, 2009 at 12:43 pm
Yes, soon I will be posting new ideas, Thank you for your support!
July 6th, 2009 at 8:12 pm
Hello! Thanks for the post. It is really amazing! I will definitely share it with my friends.
October 2nd, 2009 at 1:53 pm
I found a link to your site on , and I must say… Your site is much better.,